Bicycle TutorBicycle Tutor

Show off your bike!

Related video tutorials:
Exploded View of MF-Z012
#1
Hello all,
does anyone know where i can find an exploded drawing of the a Shimano Freewheel i believe the model is MF-Z012? it a pretty old freewheel and it looks like there are a lot of small bearing in there so i did not want to pull the whole freewheel off until i have some kind of reference.
i appreciate any help you can throw at me.
Reply
#2
This is the only EV I could find but probably different to yours.
http://techdocs.shimano.com/media/techdocs/content/cycle/EV/bikecomponents/MF/EV-MF-HG40-6-2029_v1_m56577569830609020.pdf

Might be of some help.
Normally though freewheels are not repairable and are usually replaced with new.
[font=Trebuchet MS]Ride hard or ride home alone![/font]
Reply
#3
thanks for the reply cyclerUK i appreciate it. it's not broken, at least i hope it is not. my budget is kind of low right now if i was to replace it. i am actually just trying to clean things up. the bike has been left outside for years. thanks again
Reply
#4
Try this, centerspin... http://sheldonbrown.com/freewheels.html ... near the bottom of the page.
Wheelies don't pop themselves. (from a QBP fortune cookie)
Reply
#5
Freewheel should be 20-30$ depending on what model you need...
Reply
#6
If you are taking it apart then this tool would be of great help if you can locate and attain one..... http://bicycleresearchtools.com/wheelt.html . But if the teeth are worn then you would be better off just to buy a new one.
Good maintenance to your Bike, can make it like the wheels are, true and smooth!
Reply


Forum Jump:



ISSN 1918-3445 © Copyright 2007-2010 Bicycle Tutor / Privacy Policy / Created by Alex Ramon

feed