Bicycle TutorBicycle Tutor

Show off your bike!

Related video tutorials:
Front hub
#1
Hi... just regreased the hub well and bearings
put axle bolt through then hand tighten,the bearings
keep popping out... they are well seated with teflon grease
driving me mad... any ideas folks... they are loose not caged
Reply
#2
Picture of you setup there would greatly help.
Good maintenance to your Bike, can make it like the wheels are, true and smooth!
Reply
#3
have you changed anything? sounds like too many balls or the wrong size
Reply
#4
nothing has been changed,bearings looked fine
when i looked at them... replaced dust cover
but wheel doesn't sit in the forks... wheel has a q/r skewer
i may have to mess about with the adjustment
on the cone axle... thank you
Reply
#5
check that one of the balls hasn't dropped through into the hub body, this can push the axle out of line.
Reply
#6
thanks... thats what has happened, packed so much grease
lost count of the bearings each side... a happy conclusion
thanks again
Reply
#7
glad to have been of help.
Reply


Forum Jump:



ISSN 1918-3445 © Copyright 2007-2010 Bicycle Tutor / Privacy Policy / Created by Alex Ramon

feed