Bicycle TutorBicycle Tutor

Show off your bike!

Related video tutorials:
Homemade Headset Press
#21
Great idea but Polymorph & Instamorph are very expensive. It also might not hold up to abuse.
Reply
#22
Yup, I also guess that the force you need to press in a bearing is likely too high for this plastic stuff. Plus when it starts to give a one side the bearing is no longer centred. If it has been molded to exactly fit the bearing the large surface might redistribute the force well, so this might not be an issue. Keep us posted with the results!
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Homemade Headset Removal Tool jr14 12 28,414 01-21-2016, 09:10 AM
Last Post: michaelcogburn.c
  Vertical Drill Press uses for bike fab... Bill 2 4,686 11-20-2012, 04:14 AM
Last Post: Bill
  Homemade Cone Wrench Design KC-Steve 6 16,650 08-21-2012, 01:06 AM
Last Post: xerxes
  Homemade Tire Seating Tool KC-Steve 19 18,983 07-28-2010, 12:14 PM
Last Post: Bill

Forum Jump:



ISSN 1918-3445 © Copyright 2007-2010 Bicycle Tutor / Privacy Policy / Created by Alex Ramon

feed